Sublimation raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2026-08-01 and is reviewed periodically as new material appears.
In practice, lyophilization is slower and more energy intensive than simple drying. Cycle times can range from hours to several days depending on load, container, and formulation. Amorphous materials may require excipients that help preserve structure during freezing and drying. The method is widely used for biological materials, pharmaceuticals, and foods where heat drying would cause unacceptable change. Open questions remain about scaling cycles between laboratory and production equipment, and this gap affects technology transfer.
Lyophilization removes water by freezing a material and then lowering pressure so ice changes directly to vapor. The process relies on sublimation, the phase transition from solid to gas without an intermediate liquid state. Because the material remains frozen during primary drying, the structure often stays porous. This porous matrix can rehydrate quickly when water is added back. The low pressure also allows vapor to leave the solid matrix without boiling.
A typical cycle begins with freezing, which fixes the material into a solid and determines ice crystal size. Primary drying then raises heat under vacuum so ice sublimes, often near or below the collapse temperature of the formulation. Secondary drying removes bound water that remains after ice is gone, usually by gently warming the product. Each stage balances heat input against pressure to avoid melting or structural damage. Temperature probes and pressure sensors guide the transition between stages.
Quality control for lyophilized materials includes visual inspection, residual moisture measurement, and reconstitution testing. Cake appearance can reveal process problems such as collapse, shrinkage, or meltback, although appearance alone does not prove potency. Residual moisture is commonly measured by Karl Fischer titration or by loss on drying. Reconstitution time is checked because a slow or incomplete dissolve can indicate a change in pore structure. Stability studies track these attributes over time under defined temperature and humidity conditions.
Analytical methods for lyophilized solids must account for the low moisture content and the fragile cake. Karl Fischer titration is widely used for water content, while near-infrared spectroscopy can measure moisture non-destructively in sealed containers. X-ray diffraction and modulated differential scanning calorimetry help identify crystalline or amorphous phases. Residual solvent analysis may be needed if organic solvents were used during formulation. The combination of these methods supports batch release and long-term stability assessment.
| Property | Value | Notes |
|---|---|---|
| Common synonym | Freeze-drying | Same dehydration operation |
| Typical vacuum | 10-100 Pa | Pressure during primary drying |
| Primary drying temperature | -40 to -10 °C | Below collapse temperature for many formulations |
| Cycle duration | 12-72 hours | Varies with load, container, and formulation |
| Key phase change | Sublimation | Solid ice to water vapor |
Freeze-drying is distinct from simple evaporation and from spray drying. Evaporation removes water at temperatures above freezing, while spray drying rapidly dries droplets in a heated gas stream. Lyophilization avoids high temperatures, which can be useful for heat-sensitive materials such as proteins, vaccines, and some foods. The porous cake produced by sublimation dissolves or rehydrates more quickly than a dense dried mass. Not all materials tolerate freezing or the pH shifts that can occur as solutes concentrate during ice formation.
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and fixes the structure of the sample. After freezing, primary drying lowers pressure so ice changes directly to vapor without passing through a liquid phase. Secondary drying then removes bound water that remains after ice sublimation. The result is a dry, porous solid that often retains its original shape.
Storage stability depends on water content, oxygen exposure, and temperature. Lyophilized solids are hygroscopic and can absorb water if exposed to humid air. Vials are usually sealed under vacuum or inert gas with rubber stoppers and aluminum crimps. Storage temperatures range from room temperature to refrigerated or frozen conditions depending on the material. Stability studies track potency, moisture, and physical form over time. Accelerated conditions can reveal sensitivity but may not predict long-term behavior.
Analytical methods for lyophilized materials include X-ray diffraction for crystallinity, differential scanning calorimetry for thermal transitions, and scanning electron microscopy for pore morphology. Moisture sorption analysis shows how the cake responds to humidity. These methods help distinguish amorphous from crystalline states and detect phase changes. Open questions remain about how pore structure changes during long-term storage and how best to predict collapse under varied conditions. Comparisons across studies are complicated by differences in formulation, cycle, and storage history.
== External links == Media related to Artocarpus lacucha at Wikimedia Commons Data related to Artocarpus lacucha at Wikispecies Antioxidant and toxicity activities of Artocarpus lakoocha Roxb. heartwood extract Fruit with foliage Crops for the Future: Barhal (Artocarpus lakoocha)[link removed]
=== August === 1 August – A BBC News investigation discovers that people earning more than £30,000 are being told they are not eligible to rent affordable housing in London because they do not earn enough money. 3 August – Rashid Gedel, 22, and Shiroh Ambersley, 22, are sentenced to life imprisonment with a minimum term of 27 years for the February 2021 murder of Sven Badzak in North West London, who was stabbed in a case of mistaken identity. Gedel would later allegedly murder convicted pedophile and former Lostprophets frontman Ian Watkins in prison in October 2025. 4 August – The UK government announces plans to tackle the NHS backlog with the opening of 13 new regional diagnostic centres, eight of which will be privately run. The government also wants to make it easier for the NHS to access services from the private sector. Following a trial at Derby Crown Court, Craig Crouch is sentenced to life imprisonment with a minimum term of 28 years for the murder of his 10-month-old stepson, Jacob Crouch, in December 2020. Jacob's mother, Gemma Barton, is sentenced to 10 years imprisonment for causing or allowing the death of a child. The scrappage scheme for non-compliant vehicles is extended to the whole of London ahead of the expansion of the Ultra Low Emission Zone. Following a trial at Leicester Crown Court, TikTok social influencer Mahek Bukhari and her mother Ansreen Bukhari, are found guilty of murdering two men whose car was rammed off the road following a dispute over an affair Mrs Bukhari had been having with one of the men.
==== Chemistry ==== Amylose and cellulose cannot be used as such due to poor resolution and difficulty in handling. But the carbamate and benzoate derivatives of these polymers, especially amylose and cellulose, demonstrate excellent properties as chiral selectors for chromatographic separation. A large number of polysaccharide-based CSPs are commercially available for chiral separation. These CSPs showed tremendous chiral recognition capability to resolve a wide range of chiral analytes. Many of these CSPs have been marketed by Daicel Chemical Industries, Ltd., and some of the popular ones are listed in the table.
=== Radioprotectors === A radioprotector is a pharmacon that, when administered, selectively protects healthy cells from the toxic effects of ionizing radiation. The first work with radioprotectors began as part of the Manhattan Project, a military research project to develop and build an atomic bomb.
Sources: en.wikipedia.org
Institute of Public Affairs (Inštitút pre verejné otázky or IVO in Slovak) – Australian-based think tank focusing on public policy issues. Open Society Foundations or OSF – US-based think tank with an aim of advancing justice, education, public health and independent media. Martens Centre (via the Anton Tunega Foundation) – Belgium-based think tank and political foundation of the European People's Party (EPP) which embodies a pan-European mindset and promotes Christian-democratic and liberal-conservative political values.
The original fragile and heavy glass containers presented challenges for transportation, and glass jars were largely replaced in commercial canneries with cylindrical tin can or wrought-iron canisters (later shortened to "cans") following the work of Peter Durand (1810). Cans are cheaper and quicker to make, and much less fragile than glass jars. Can openers were not invented for another thirty years. At first, soldiers would cut the cans open with bayonets or smash them open with rocks. Today, tin-coated steel is the material most commonly used. Aseptically processed retort pouches are also used for canning. Glass jars have remained popular for some high-value products and in home canning.
Radio Frequency Identification (RFID) – identification tags containing a tiny radio transponder (receiver and transmitter) which are attached to merchandise. When it receives an interrogation pulse of radio waves from a nearby reader unit, the tag transmits back an ID number, which can be used to inventory goods. Passive tags, the most common type, have a chip powered by the radio energy received from the reader, rectified by a diode, and can be as small as a grain of rice. They are incorporated in products, clothes, railroad cars, library books, airline baggage tags and are implanted under the skin in pets and livestock (microchip implant) and even people. Privacy concerns have been addressed with tags that use encrypted signals and authenticate the reader before responding. Passive tags use 125–134 kHz, 13, 900 MHz and 2.4 and 5 GHz ISM bands and have a short range. Active tags, powered by a battery, are larger but can transmit a stronger signal, giving them a range of hundreds of meters. Submarine communication – When submerged, submarines are cut off from all ordinary radio communication with their military command authorities by the conductive seawater. However radio waves of low enough frequencies, in the VLF (30 to 3 kHz) and ELF (below 3 kHz) bands are able to penetrate seawater. Navies operate large shore transmitting stations with power output in the megawatt range to transmit encrypted messages to their submarines in the world's oceans. Due to the small bandwidth, these systems cannot transmit voice, only text messages at a slow data rate.
replication 1. The process by which certain biological molecules, notably the nucleic acids DNA and RNA, produce copies of themselves. 2. A technique used to estimate technical and biological variation in experiments for statistical analysis of microarray data. Replicates may be technical replicates, such as dye swaps or repeated array hybridizations, or biological replicates, biological samples from separate experiments which are used to test the effects of the same experimental treatment.
{\displaystyle {\begin{aligned}c&=\left|{\boldsymbol {u}}\right|{\sqrt {(n^{2}+nm+m^{2})}}&&\approx 246{\sqrt {((n+m)^{2}-nm)}}\\d&={\frac {c}{\pi }}&&\approx 78.3{\sqrt {((n+m)^{2}-nm)}}\\\end{aligned}}}
Sources: en.wikipedia.org
== Last Universal Common Ancestor (LUCA) == Some authors equate models of the origin of life with LUCA, the Last Universal Common Ancestor of all extant life. This is a serious error resulting from failure to recognize that L refers to the last common ancestor, not to the first ancestor, which is much older: a large amount of evolution occurred before the appearance of LUCA. Gill and Forterre expressed the essential point as follows:
. In conventional chromatography, separation of similar compounds can be improved by gradient elution. In MEKC, however, techniques must be used to extend the elution range to separate strongly retained analytes. Elution ranges can be extended by several techniques including the use of organic modifiers, cyclodextrins, and mixed micelle systems. Short-chain alcohols or acetonitrile can be used as organic modifiers that decrease
States that produce refugees are sites of social upheaval, civil war, even genocide. Most refugees experience trauma. It can be in the form of torture, sexual assault, family fragmentation, and death of loved ones. Refugees and immigrants experience psychosocial stressors after resettlement. These include discrimination, lack of economic stability, and social isolation causing emotional distress. For example, not far into the 1900s, campaigns targeting Japanese immigrants were being formed that inhibited their ability to participate in U.S. life, painting them as a threat to the American working-class. They were subject to prejudice and slandered by American media as well as anti-Japanese legislation being implemented. For refugees family reunification can be one of the primary needs to improve quality of life. Post-migration trauma is a cause of depressive disorders and psychological distress for immigrants.
== Scope and funding == As of 2021, the FDA had responsibility for overseeing $2.7 trillion in food, medical, and tobacco products. Some 54% of its budget derives from the federal government, and 46% is covered by industry user fees for FDA services. For example, pharmaceutical firms pay fees to expedite drug reviews. According to Forbes, pharmaceutical firms provide 75% of the FDA's drug review budget.
Sources: en.wikipedia.org
Primary drying removes ice by sublimation under vacuum. Secondary drying removes water that is bound to the material, often by warming the product after most ice has left. Both stages occur below temperatures that would cause unwanted melting.
Sublimation requires the solvent to remain solid so vapor leaves without passing through a liquid phase. If the product melts, the porous structure can collapse and drying becomes uneven. Maintaining frozen conditions preserves the intended physical form.
No, freeze-drying is a dehydration method, not a sterilization step. It can reduce water activity and limit microbial growth during storage, but it does not reliably kill microbes or remove endotoxins. Sterility must come from separate validated processes.
Most lyophilized products are stored in sealed containers at controlled temperature and humidity. Some require refrigeration, while others are stable at room temperature. Protection from light and moisture is often necessary.